A driveway gate opener moves a heavy gate many times a day, through summer heat and winter rain, often on battery and solar power. When it fails, you are stuck pushing the gate by hand or leaving your property open.
Braxdyne provides gate opener repair in Sacramento and across Placer, El Dorado, Yolo, Sutter and San Joaquin counties. We work on swing gate and slide gate operators at homes, including common residential brands such as LiftMaster, Mighty Mule, DoorKing, Viking, US Automatic and Ghost Controls. We find the real cause and tell you plainly what it takes to fix it.
Every visit starts with a $0 service call and a free estimate, and we agree on the price before any work begins. Our work carries a 90-day labor warranty, and parts we install carry a 1-year parts warranty. We are open 7am to 9pm every day and take emergency calls until midnight.
Braxdyne is not yet licensed by the CSLB (our license is in process), so we only take minor repairs under $1,000 total for parts and labor that need no permit, and we refer bigger jobs to a licensed partner.
Signs you need gate opener repair
- The opener hums, clicks or beeps, but the gate does not move.
- The gate opens partway and stops, or starts to close and then reverses.
- The gate went dead after a power outage, a storm or a tripped breaker.
- The battery backup beeps, or the gate quits after a few cycles in a row.
- A solar gate opener slows down or stops after a few cloudy days.
What we do on a visit
- Ask what changed. An outage, a storm or a bump from a car often points us to the cause.
- Check the gate by hand. With the opener released the way the manufacturer intends, we test whether the gate swings or rolls freely. A binding gate makes any opener look broken.
- Test power and batteries. We check incoming power, the transformer, fuses, the backup battery and, on solar gates, the panel and charging.
- Read the control board. We check error codes, limit settings, force and obstruction sensitivity, plus the motor, gears and wiring.
- Agree on a price. You get our recommendation and the price before any work starts.
- Repair and verify. We fix the problem, cycle the gate several times, confirm the safety devices stop or reverse it, and walk you through what we found.
Common gate opener problems we fix
Dead after a power outage. Outages and surges can trip breakers, blow fuses, scramble settings or damage a control board. Sometimes the gate only needs its limits relearned. We test each step before replacing anything.
Weak batteries and solar. Gate batteries wear out, and long Sacramento Valley summers are hard on them. A dusty or newly shaded solar panel may not keep up with how often the gate runs. We test the battery and charging, and clean or reposition the panel where the mount allows.
Limit and force settings. Limits tell the opener where open and closed are, and force settings tell it how hard to push. When these drift, the gate stops short, slams or reverses. We reset them carefully, because force set too high can make a gate unsafe.
Motors, gears and arms. Stripped gears, a worn actuator arm or a failing motor can all cause humming with no movement. We repair or replace the worn part when the job fits our limits.
Safety devices tripping. The UL 325 safety standard for gate operators calls for entrapment protection, and many newer operators will not run normally if a monitored photo eye or safety edge is blocked, faulty or unplugged. We fix the device at fault rather than bypass it.
New electrical circuits, new wire runs or a full new gate system are outside what we take on. If your gate needs any of that, we will tell you up front and refer you to a licensed partner.
What you can safely check yourself
Keep children, pets and cars clear of the gate the whole time.
- Power. Look for a tripped breaker or popped GFCI outlet and reset it once. If it trips again, leave it off and call us.
- Remote batteries. If the keypad works but your remote does not, try a fresh battery in the remote.
- Obstructions. Look along the gate path for bins, branches, gravel or toys.
- Photo eyes. Gently wipe the lenses with a soft cloth and make sure nothing blocks the line between them.
- Manual release. Only use it if your opener manual says how, and follow those steps exactly.
Never climb on or ride a gate, and never reach into the opener or gate path while it can move. Do not open the control box or bypass safety devices.
When to call a technician
- The opener hums, grinds or clicks but the gate does not move.
- The gate still reverses after you clean the photo eyes and clear the path.
- A breaker trips again, you smell burning, or you see damaged wiring or water in the control box.
- The gate does not stop or reverse when something is in its way.
More gate help
Opener trouble is often tied to the gate itself or its controls. See sliding gate repair, swing gate repair and gate keypad, remote and safety sensor repair, or start at our main electric gate repair page. For more homeowner checks, read Electric gate opener not working?
FAQ
Why does my gate opener hum but the gate does not move?
Common causes include a weak battery, stripped gears, a failing motor or a gate that binds by hand. We check the gate first, then the power and the opener, so you only pay for the fix you need.
My gate stopped working after a power outage. Is the opener ruined?
Not always. A tripped breaker, a blown fuse, a drained battery or lost limit settings are common after outages. We test each one before recommending a part.
Can you install a brand new gate opener?
Only when the whole job fits the limits above and needs no permit or new wiring. If it does not, we will say so right away and refer you to a licensed partner.
Gate opener not working? Call Braxdyne at (916) 848-5050 or text a photo of your gate opener and its model label. We are open 7am to 9pm every day, with emergency calls until midnight, a $0 service call and a price agreed before any work.



